Maxxon Commercial Profile 13011 Maxxon Commercial Profile is a spray-applied, direct-to-concrete cleaner and profiler designed to purge the insoluble salts and contaminants from the concrete surface, while creating a CSP of 1-4 without the need for shotblasting
Isolate Features- 4 gallon pail
- Increases porosity and reduces high alkalinity, creating a clean concrete surface that promotes bonding of Maxxon primers and underlayments
- Biodegradable and cleans up easily with water
- Cleans and profiles old, new, compromised, and chemically-abated concrete to a CSP of 1-2 in approximately 2 hours and up to 3-4 hours with a second application
- Ideal for dust-free environments where mechanical profiling is not feasible
- Single component – ready to use
- Muriatic/HCl-free formulation
- Zero VOCs
- Easy to apply – hand-held spray application; no shot blasting required
- Application Temperature: 40 – 90 °F (4.4 – 32 °C)
- Coverage: 225-250 ft2/gal (5.5-6.1 m2/L) or 900-1000 ft2 (84-93 m2/pail)
Where to use- Virtually all above-, below- and on-grade concrete-based construction applications
- Interior old, new, compromised and chemically-abated concrete
Limitations- For interior use only
- Do not allow the product to freeze
- For use over subfloors containing asbestos, contact Maxxon Corporation
- Do not use if ambient and/or concrete surface temperatures are below 40 °F (4.4 °C) or above 90 °F (32 °C)
- If desired, construct a mock-up to verify compatibility with finished flooring
- Do not clean the concrete substrate/subfloor with oil-based or silicone-based sweeping compounds. These compounds leave a film on the subfloor surface, interfering with bond development. Instead, use a vacuum with a HEPA filter to clean the concrete substrate/subfloor
- More than treating the surface with Maxxon Commercial Profile is required for slabs containing petroleum-based products. Maxxon Commercial Isolate is required to prevent the migration of residual petroleum
- Maxxon Commercial Profile will not remove heavy glue residue, for example, where ridges can be felt (Glue should be removed by physical means)
- Not effective on damp or wet slabs
- Must come in contact with the concrete surface. Thick build-ups of dirt, dust, etc., must be removed via power washing or mechanical means. In addition, Maxxon Commercial Profile will not work over coatings such as an epoxy or heavy acrylic; if such a coating exists, shot blasting is required
- Because all slabs vary, a consistent CSP may not be achieved through one application
- Profile must be thoroughly removed from the concrete slab before installation of any floor system. The residue will act as a bond breaker in many situations
- Do not use Maxxon Commercial Profile over gypsum underlayments
- Metal thresholds, floor vents, and aluminum window frames should be removed or protected to prevent damage. Metal tips should not be used on spray equipment as Maxxon Commercial Profile will react with the metal and damage the tip
|
