TAK35PIN Pearl 1/4" Tuck Point Pin Diamond Bit
Pearl Abrasive Tuck Point Pin Diamond Bit, TAK35PIN
Use with a die grinder at 8,000 to 15,000 RPM
Note: Grind with sides of the pin NOT the tip
- Fits die grinders
- Size: 3-1/2" x 1/4"
- Cuts away mortar in hard-to-reach inside corners or irregular joints that blades cannot reach
- Cut extra hard mortar
- Get close to window or door frames without over-cutting
- Easily remove mortar around a single brick without cutting into other mortar
- Remove mortar from a vertical brick joint without cutting adjacent bricks
- Great crack chaser tool
- Less dust than tuck point blades
Questions & Answers (1)
do you have a Military price?
do you have additional diameters of bits? 5/16, 3/8, 1/2"
How long can I expect the bit to last in moderately hard mortar, 20 years old.
will the bits work in a standard drill, hammer drill?
reply to Ken Smith: email@example.com
We do offer a veterans discount USAVETERANS will save you 5% on your order. As for bit sizing this is all that is offered by pearl. In addition life of these bits really does depend on the application and we wouldn't truly be able to give an accurate life expectancy per bit. These bits also are to be attached to die grinders.