I used these on 900 SF of 18" x 36" porcelain tile over a fairly bad old mill floor. Covered it first with Ditra mat then used 1/2" notch trowel - back buttering and using Spin Doctors With the Anti Friction disks at all intersections. The tile followed the roll in the floor but there is almost no discernible lippage. For better than I thought I could achieve. You must use the disks if you are going to apply any kind of tension on the tile, and you can put quite a bit on if needed.
I have had my own full time Tile Installation business for over 29 years and I think these things are great. You do need to know what you're doing though. Not for rookies. The mud application needs to be close and then you can Dial it in with these. 2 Thumbs UP
6864 RTC Spin Doctor 1/16" White Threaded Spacers/Posts
- Product code: 6864
- Manufacturer: RTC
Spin Doctor Tile Leveling System, 1/16" White Threaded Posts
Large format tile is becoming increasingly popular on both residential and commercial job sites. Although tile is getting bigger, thicker, and becoming more difficult to install, the new RTC Products Spin Doctor Tile Lippage Control System is here to help.
Attaining a flat and level tile floor or wall has never been so simple. Other systems require the use of unique tools or pliers, but the Spin Doctor tile leveling system can be installed by hand. The patented free-spinning leveling caps can be spun down the threaded post with just one hand; the minimal effort required is notably helpful when installing large format tile.
- Spin Doctor 1/16" spacers/posts are available in 100 piece or 400 piece boxes.
- Safe to use with tile up to 3/4" thick.
- For a thicker grout joint, 1/8" Spin Doctor posts are also available.
How to Use the Spin Doctor Leveling System
- Place your tile in the desired position.
- Position the threaded spacer posts under the exposed edges of the tile to best suit the tile size and layout. Posts can be used in multiple configurations, such as a linear spacer, a "T" spacer or a four-corner spacer.
- Make sure there is direct contact between the spacer and the tile without mortar in between.
- Place the rotating cap on the top of the threaded spacer post and spin the cap down to the tile surface.
- Turn cap as needed until all adjacent surfaces are flush.
- Remove spacer posts and caps with a rubbet mallet once tile adhesive has cured.
- Caps are easy to clean and re-use!
Ratings & Reviews
Most Helpful Reviews
So let me start with saying I was not big on using lippage control systems to begin with but after using RLS for most of 2016 especially on plank it has become a necessity. Although I was happy with RLS I figured I would try the Spin Doctor and within the first 10 sq ft. I was not impressed at all. When spinning the cap the tile shifted and the joint would pinch after a few more feet I was able to get a more consistent result but was not thrilled about it. I finished the job and knocked off the cap and the floor was good, not great. The other issue I have is once the job is done I had to remove the waste from each cap..... I am sticking to RLS! In my opinion, the spin doctor system was made for homeowners, not for contractors.