Raimondi Circular Shaping Tool
Product Details
Product Details
LTMOTOKOMPAS Raimondi Circular Shaping Tool
Thin panel tool makes circle or rounded corners
Features
- Includes cutting-off plier for 3-6 mm thickness tiles.
- Make both centered and off-centered cuts
- Depending on suction cup placement, a number of circular and semi-circular cuts of all sized can be achieved
- Minimum 12" (30cm) to maximum 40" (100cm) diameter.
- Half/bullnose profiles can be performed on slabs and tiles with a thickness from 14/" (5mm) - 1/2" (12 mm).
- Available radius: 6 mm, 10 mm, 12 mm.
- Diamond scoring wheel Ø 16 mm with pin and bearings
- 45° bevel (jolly) profiles can be performed on slabs and tiles with a thickness from 3 to 12 mm
- For finishing/polishing the shaped edges, use an angle grinder freehand (max 1400 rpm) with diamond pads
- To complete the cut of the hole is almost always necessary to perform slicing with an angle grinder and removing the cloves afterward
- Can be used dry (with a dust extractor) or with water (with kit for wet cut art.433PWW A).
- Suitable with almost all angle grinders with power between 600-1100W
- Grinder with ⅝” (11mm) arbor attachment.
- Equipped with: “RV 175” vacuum pump suction cup with vacuum gauge for use on textured surfaces, scoring device with diamond wheel Ø 16mm, housing unit for angle grinder for shaping edges, cutting-off plier for snap after the scoring cut, use and maintenance manual.
- Angle grinder and diamond tools are not included.