Blanke Aqua Shield Outside Corner

(0) No Reviews yet
SKU: 540-900
Contractor pricing

Product Details

Product Details

Blanke Aqua Shield Outside Corner

Blanke AQUA SHIELD is a thin waterproofing fabric that can be applied with thin-set mortar to most surfaces that are dry, flat, and structurally sound. Tile can be installed immediately on fabric without the cure time required for liquid-applied products. In addition to waterproofing, the Blanke AQUA SHIELD forms a vapor barrier making it ideal for steam rooms and saunas. A wide range of convenient accessories is available such as the Blanke AQUA CORN-I and CORN-A for corners, BLANKE AQUA SA, a self-adhesive tape for a quick, convenient taping of seams, and the BLANKE AQUA SEAL, a waterproof polymer adhesive for sealing seams and preformed corners.


  • Lightweight waterproofing fabric
  • No waiting to install tile
  • Superior tensile strength
  • Superior workability
  • Crack isolation properties
  • Suitable for interior and exterior applications
  • Resistant to saline solutions; acids; alkaline solutions; many organic solvents; alcohol; and oils
  • Resistant to micro-organisms, deterioration and rot
  • Waterproofing walls and floors in bathrooms; showers, saunas, locker rooms, and exterior decks, patio, balcony, and terraces not over occupied space

Instructions for Installing Blanke Aqua Shield Outside Corner

  • The substrate must be clean, flat, dry, and load-bearing. Priming the substrate is recommended
  • Treat drains, pipe surrounds, corners, wall-to-wall connections and wall-to-floor connections first per directions given in BLANKE AQUA SHIELD Installation Instructions
  • Apply the thin-set to the substrate by using a 1/4” x 3/16” V-notched trowel
  • Press BLANKE AQUA CORN A into the thin-set by using the flat side of the trowel, ensuring 100% contact with the substrate
  • Make sure to press out any air pockets
  • In applications subjected to constant and extremely moist conditions, use BLANKE AQUA SEAL waterproofing adhesive to seal the overlapped seams.
  • Flatten out any excess BLANKE AQUA SEAL at the connections of corners and bands

Suitable Substrates for Bonding:

  • Plywood, drywall, backer board, cement

Technical Data

  • Material: Polyethylene film with a fleece glued to the top and bottom
  • Thickness of the PE Film: approx. 0.2 mm (approx. 0,008 inches)
  • Width/in: 4 inches
Questions & Answers
No questions available

Be the first to Write a question

Ratings & Reviews

No reviews available

Be the first to Write a Review