Raimondi Leveling Spacers have been sold in Europe for quite a few years and finally we're able to introduce them to you!
If you're a tile installer, you're well aware of how difficult it is to properly set flexible, large format, heavy, or low-thickness tiles because, often times, the floor foundation is uneven and/or contains imperfections.
Tiles that seemed uniformly leveled while first installing them can show differences as the tile adhesive sets, compromising the overall aesthetics of your initial hard work.
With the Raimondi Leveling Spacers, this potential is no longer a threat to your perfect tile project.
In addition to ensuring the proper leveling of tiles, this system helps speed the tile setting process.
System Starter Kit includes floor plier, 100 regular clips, and 100 wedges
Greatly improves the overall quality of your tile project
Both installation and removal of the spacers are quick and easy!
Sturdy Tile Wedge holds tiles better than competitors
Works well with both Wall and Floor projects!
Tiles are not pulled from the thinset, they're pushed into it.
Rather than worrying about voids and coverage, RLS spacers further enhance your thinset adhesion to your tiles!
Wedges size: 3-1/2" Long x 3/4" Wide.
Regular Leveling Clip size: 1/8" to 1/2" tile, 1/16" joint.
Large Leveling Clip size: 1/2" to 3/4" tile, 1/16" joint.
Minimum required joint: 1/16", (1.5mm), max 1/8" (3mm).
Tile thickness minimum required 1/8", (3mm), max 3/4" (20mm)
How to use
STEP 1: After spreading your tile adhesive, insert leveling spacer underneath the tiles along the 4 sides, use traditional spacers as you normally would to square up the corners. For larger tiles, it may be necessary to "double up", using 2 leveling spacers for each side.
STEP 2: Set the tile and beat it with a rubber mallet
STEP 3: Use the special traction-adjustable pliers to insert the wedge into the leveling spacers, paying attention not to pass the breakpoint.
STEP 4:Once the tile adhesive has been allowed to set. Remove the leveling spacers with the traction-adjustable pliers, rubber mallet, or kicking them out with your feet.
5206 Raimondi Tile Leveling System
, 11/16/2012 By tile dog(, idaho)
although very expensive it does an excellant job - most important buy a dasco pro 7.5 inch ultra bar to hammer free the plastic clips - if you don't get a clean brake it's a bitch to remove the plastic before you move on to grout
BUY THEM, 4/7/2013 By Andy(Coastal, Maine)
This system is the best thing that has happened to large tile. Will always use them. I am hooked on them. They pay form themselves!
can try, 7/25/2013 By Rios(, Tx)
It works. Didn't like the fact sometimes the strip doesnt break clean and remove the tiles is needed.
Awesome!, 8/7/2013 By Quality Tile Setting(Oakland, Oregon)
There are by far the best System on the market! Been Using them for the past month.
after fighting with the Tuscan System, these wedges proven much easier and MUCH better in all ways. They are so easy to use, you can set and tighten them with one hand.we are using both the 1/16 and the 1/8 clips. this system can take much more stress then the Tuscan and has a larger flattening contact with the tile. we used them on 20'' by 20'' tiles on the floor and 16'' by 16'' on the walls and it is amazing how much better you feel at the end of a day. no more lifting wet tile or pushing down on them to make them flat.
Thank you for carrying this system!