MLT Leveling System TP-0.8 Ready Line Single Use StrapMLT Systems "Ready Line" are single use straps for tile leveling. With the single piece strap, there is no more pre-assembly necessary. The single piece strap is designed with the commercial contractor in mind; no more extra labor costs associated with base plate assembly and sorting the cleanup.
Features- For use in grout joints 0.8mm-1.5mm
- Convenient single use strap used in conjunction with tensioning caps for the installation of floor and wall tiles
- 500 straps per bag
- New plastic formulations for more reliable breaking
- Recyclable leading to less environmental waste
- Designed and engineered to be disengaged under tension to allow cleaning of grout joints and seams, or to re-position the tiles/slabs just with a slight side pressure
- Rubber Feet and Steel Tongue Inserts for Caps avoid scratching and extend Cap life
- The slot on the top of the cap will accept a Stainless Steel tongue insert in cases where the ratcheting teeth may become worn. This will greatly prolong the working life of each cap
- Caps, rubber feet and steel inserts are all sold separately
MLT System Installation- No more Pre-assembly required
- Spacing of each re-usable connecting tab should not exceed 20” to 24” apart, during installation
- Do not place them under a four-corner junction as lippage may result and also greatly increase the difficulty to produce a straight grout joint line
- Once the pre-assembled re-usable connecting tab and base plate is in place, proceed using standard installation procedures
- Upon completing the "set" of the tile or stone, lower the tension locking cap over the single use strap connecting tab to tile or stone surface then, slide cap in the direction of the grout joint to engage the lock
- Place installation/removal tool atop the tension locking cap to engage the reusable connecting tab and tension MLT System, to create a lippage free surface
- If additional cleaning of grout joint line is required after MLT System has been tensioned: remove cap, clean joint line, re-engage cap and re-tension
- To remove set tension setting dial on “S” for “Snap”. Place installation/removal tool atop re-usable cap and engage the reusable connecting tab
- When using MLT System for installations of thin tile, unglazed, or highly polished materials, it is strongly recommended to use the fitted Rubber Pad accessory under the re-usable tension locking cap
|
