Innovis Better Bench Pre-formed Floating Shower Bench
Product Details
Innovis Better-Bench Pre-Formed Floating Shower BenchThe Better-Bench is quick and easy to install, replacing other more complex DIY methods. These fully independent units can be mounted to most vertical surfaces quickly and easily, saving the tile installer valuable time. What once took hours can now be done in about 30 minutes! Features
Click Here to Learn How to Build a Floating Shower Bench/Shelf from Innovis Corporation |
32 questions
When mounting the better bench in a tiled shower stall, should the underside of the better bench be tiled exactly like the top and sides or left untiled?
by Jay 7/18/2015 2:20:48 pm
Normally the underside of the Better Bench is not tiled. If you do tile the underside of the Better Bench a special thin-set will be required to bond to the metal.
We didn't have enough room for the BB-30 seat, so we installed the BB-24 seat, but it is too little. Is it possible to build out the BB-24 from 17" x 17" x 24 to 18" x 18" x 25 1/2 by adding tile on top of the existing tile?
by Julie 8/21/2015 12:38:53 am
This installation may work however you would void any warranty by Innovis. You are also potentially going to have issues with the tile as it may not adhere properly causing them to break and or come loose
When installing the BB-ADJR at a length of 48" with walls supporting the unit on each side (and back), what spacing should the invisabolts be positioned at? I would assume with the bench being supported at the walls you would want the two bolts closer to the center?
by Dave 4/2/2016 9:29:03 am
INVABOLTS should be mounted in the three holes closest to the center of the unit when installing the BB-ADJR at a length of 48'' with three walls supporting the bench.
Can the BB-ADJR seat be installed into a two wall corner, no third wall, and with two Invabolts for support? The bench will be extended to 45 inches.
by Alessandro Paoletto 4/25/2016 11:16:53 am
Yes, you can either use two INVISABOLTs or one BT-17S to install the BB-ADJR in a two-wall corner.
Can the BB-ADJR bench be cut shorter than 33-1/2"?
by Jim Reed 4/28/2016 2:36:44 pm
Yes, the BB-ADJR can be cut down to a smaller size. Innovis suggests cutting off an equal length from both pieces of the unit using either a circular saw and metal blade or a pair of aviation snips.
26 reviews
Great product for smaller showers.
by Custom Tile & Interiors -
We always use Better Bench products. They are quality and well priced!
Great Product
by Jaydon
Great product we use to implement a seat!