Details

  • 030049 Carriage Tray Wheels for Husqvarna Tilematic TS 250X, Tilematic TS 250XL, Target TileMatic G2, Felker Tilemaster Plus, & Tilemaster XL Plus Tile Saw.

Question & Answers

Why does 2 wheels have offset bolts and 2 wheels have centered bolts?

This allows the Husqvarna carriage tray to be adjusted up and down. The purpose of this is to make the carriage tray perpendicular (90 degrees) to the tray. The 2 offset wheels should be placed on the same side of the tray. If you prefer all centered bolts we sell these bolts individually (item 581240201).

What is the dia. of the wheels and the width of the groove, I am try to fit the wheel on an old saw

1-7/16" diameter wheel with 3/16" width groove.

Ratings & Reviews

4.7
3 stars
0% 0 reviews
2 stars
0% 0 reviews
1 star
0% 0 reviews
Based on 3 Reviews

Most Helpful Reviews

|

Wonderful

by
Just what the doctor ordered, saw is ten years old and the tray was sloppy , rolling like new now!

Was this review helpful?

|

carriage wheels

by - verified purchaser
I received two sets of wheels for double trays thinking it would be a quick change but when I opened the bag two wheels where like the ones shown in the picture and two wheels were adjustable that was for both bags. It is a real pain to install especially on felker with double trays. Every time you think there are right you have to pick up the tray to tighten the wheels and they move and you have to adjust them again. All four wheels should be the same like the picture and it would take about 5 minutes to change not one hour.

Was this review helpful?

|

Carriage Tray Wheels

by - verified purchaser
Transaction was very smooth and professional. Product was very satisfactory and solved my problem.

Was this review helpful?