7369 Stone Tech Honing Powder 800 Grit Extra Fine
- Product code: 7369
- Manufacturer: Laticrete
$60.00 to $359.00
Laticrete Stone Tech Honing Powder 800 Grit Extra FineFeatures and Benefits
- Creates honed finishes
- Sets up stone for polishing and shining
- Different grits eliminate mild to deep scratches
- Coverage (600 Grit, 800 Grit): 750-1,500 sq ft per pound
- Natural stone such as marble, limestone, travertine and terrazzo
- Read entire label before using. Use only as directed
- Always test in a small inconspicuous area to determine ease of application and desired results
- Allow new grout installations to cure for a minimum of 72 hours prior to application
- Make sure surface is clean, dry and free of waxes and coatings
- If surface is heavily soiled, pre-clean with StoneTech® Professional KlenzAll™ Cleaner if needed
- Mask any surfaces not intended to be treated. If you are using a variety of abrasive grits, ensure that the surface is well rinsed and a new pad is used for each changeover.
- Apply approximately 1/2 cup Honing Powder plus 1 cup clean water to stone surface
- Refinish using a hand orbital sander or weighted floor machine at 130–140 lbs, 175 rpm, fitted with a natural hair pad. Keep compound wet while refinishing with plenty of water.
- Add Honing Powder as needed
- Refinish area until the desired level of hone has been achieved
- Rinse well and use a wet vacuum or hot water extraction unit to remove all remaining compound
- Clean equipment with water
- Use successively higher grits of Honing Powder to close the face of the stone and follow with StoneTech® Professional Polishing Powder and StoneTech® Professional Shining Powder as applicable.