Details

Pearl P4 Turbo Mesh Blade for Porcelain and Granite

Turbo-mesh rim virtually eliminates heat caused by friction for clean, chip-free cuts through porcelain, ceramic, and stone.

Tile Cutting Technology

  • Thin Turbo-Mesh rim and core for fast cutting and minimal chipping
  • Ideal for cutting extra hard ceramics, porcelain and other hard/dense materials
  • Extra long life
  • 10mm diamond rim
  • Available in 4", 4.5", 5", 7" and 10" diameters
  • 7/8, 20mm, 5/8" arbor
  • Wet or dry cutting
  • 13,300 maximum RPM

Question & Answers

Be the first to ask a question

Ratings & Reviews

Based on 4 Reviews

Most Helpful Reviews

|

great blade

by - verified purchaser
used it for huge porcelain job worked great for all miters my saw could not make

Was this review helpful?

|

10" Pearl Turbo Mesh Blade

by
Very pleased, fast clean cuts. Purchased for a new Pearl VX10 Saw.
Also very pleased with Contractors Direct service and fast shipping.
Thanks.

Was this review helpful?

|

Cuts Good

by
Cuts better than expected. Very clean. Treat her with care though so you do not compromise the rim.

Was this review helpful?

|

10" and 5" Pearl blade

by
This is a good blade for the money but the biggest draw back is the thicker reinforcement at the arbor hole may not allow you to put the nut back on. The 10 inch worked ok for my Brutus 10" wet saw but the 4.5" did not fit my Alpha 5" hand held wet/dry arbor saw. The nut did not have enough thread to put it back on.

Was this review helpful?