6565 Imer MS350 Series 14in Masonry Saw

• Free Shipping from IMER factory warehouse
• 14" Blade capacity, 1" arbor.
• Motor 2850 Rpm, Blade 2150 Rpm.

MS 350SC

• 1.5 hp motor runs on 110 volts, 15 amps
• Head tilts to 45 degrees
• Optional 2.8 hp single phase 220 Volts motor (call for pricing)

MS 350F

• 1.5 hp motor runs on 110 volts, 15 amps
• Fixed Head
• Lighter than MS 350SC

MS 350G

• 5.5 hp Honda motor with oil bath clutch engine
• Gear box drive means less vibration and maintenance.

• 16" x 16" Heavy Duty table, cuts 4 bricks at once
• Rigid single arm motor mount allows for cutting large pieces
• Built in stand with wheel kit
• Low voltage coils protect the vital components such as the on/off switch and motor from low or inadequate power sources.
• Hi-torque motors and serpentine drive belts ensure fast and smooth cutting performance
• Blade guards and panic stop buttons that keep safety inspectors happy
• The cutting tray rides on 1" square steel bars that are fully adjustable, these saws remain accurate all the time!
• The cutting tray rollers keep the tray in place at all times the tray will not wheelie up n' down as you pass a block through the blade
• A plunge stop is designed into the saw, the blade cannot cut into the cutting tray
• The box steel frames are light and very rigid, this allows for the single arm design, pass extra wide and extra long materials with no problem